STRIP-IT™ - Instructions to apply using Foam Applicator - Part of the PACE ACBD System® sanitation program
Instructions for using a Foam Applicator to
apply
STRIP-IT™
Foam Applicator Kits
Standard Kit part #: HPU10001
Stainless Steel Kit part #: HPU10002 (3.4
gpm
)
Stainless Steel Kit part #: HPU10003 (5.7
gpm
)
Click
HERE
to view or download Stainless Steel specification sheet!
Parts included:
Foamer Nozzle
(shown)
Quick-connect Coupling
(shown connected on right)
Strainer / Filter Check Valve
Plastic Tubing
Tubing Clamp
*Assembly tools are NOT provided!
The Foam Applicator Kit or its individual parts are
available directly from
or from one of our product
distributors.
*Distributors may have different part #s.
NOTE 1:
The foam applicator should be used with a pressure washer delivering a minimum of
1000 psi
and a maximum of
3200 psi
(maximum of
4000 psi
for stainless steel models).
Click
HERE
for a full-size 2-minute instructional video with audio
on how to assemble the Foam Applicator Kits.
NOTE 2:
To avoid clogging the internal parts of the foam applicator,
use clean water for the pressure washer and ensure that a strainer /
filter like the one supplied with the Foam Applicator Kit
is attached to the end of the plastic tubing.
NOTE 3:
Use safety equipment and clothing recommended in the
MSDS
(Material Safety Data Sheet)
for the handling of this product.
Directions: (* applies to Standard Kit only)
* For Stainless Steel Kit application
- refer to the Specification Sheet
HERE.
Prepare sufficient use-solution by diluting
1 part of
STRIP-IT™
to 3 parts of water.
Mix thoroughly.
Fill a container such as a backpack sprayer tank with use-solution.
Connect the foam nozzle to the pressure washer wand tip using the quick connection.
Using plastic tubing, connect the container to the barbed fitting on the foam nozzle.
Fully open the valve on the foam nozzle.
This will deliver an approximately
1 : 32 dilution of
STRIP-IT™
to the surface being cleaned.
Activate the wand trigger.
Under these conditions the foam produced should resemble shaving foam.
Apply foam evenly to all surfaces to be cleaned.
Allow to penetrate for about
5 minutes
then disconnect the foam nozzle and rinse surfaces with clean water at high pressure.
For instructions on the use of our products
in your specific application,
please contact your
product
distributor.
Registered Customer Login
or from one of our product
